Product systems: Concrete and mortar additives

BOTAMENT® UV 2 HP is a sealant for mechanically and chemically loaded surfaces in interior and exterior areas.

BOTAMENT® UV 2 HP is suitable for the refurbishment of damaged concrete surfaces particularly in the agricultural sector.

• Highly abrasion-resistant
• For surfaces subject to high mechanical and chemical stress
• Highly resistant against organic and inorganic acids
• Wide choice of applications
• For walls and floors

Impregnation and sealing of:

• concrete
• cement screeds
• existing reaction resin coatings

The substrate must be in the following condition:

• clean and frost-free
• stable
• free from grease, water soluble coats, cement laitance, separating agents and loose particles

cold, dry and frost-free at least 12 months in its original sealed container

component A : B = 10 : 3

~ 45 minutes

after ~ 24 hours

• add B component to A component and mix both together with a slowly rotating mixer for at least 3 minutes
• to prevent mixing errors pour BOTAMENT^® UV 2 HP afterwards into a clean container (scratch the container clean) and mix again
• roll out the ready mixed material with a short-pile sheepskin roller onto the dried primer across the entire area
• apply the top coat onto the dried base layer with a short-pile sheepskin roller

Surface sealings made of BOTAMENT^® UV 2 HP should be done applying at least two layers.

To achieve a slip-resistant surface the first layer of BOTAMENT^® UV 2 HP must be scattered while fresh with dried quartz sand of a grain size between 0.1 – 0.3 mm.

+ 8 °C to + 30 °C

generally 3 °C over dew point

relative humidity ≤ 85 %

~ 0.30 kg/ m² (per layer)

≤ 48 hours

BOTAMENT® UV 2 HP must be protected against moisture while curing.