Product systems: Concrete and mortar additives

BV 2 Floor sealant 2c

BV 2

BOTAMENT® BV 2 is a top-quality impregnation and sealant with a silk sheen for mineral floor surfaces in interior and exterior areas.

BOTAMENT® BV 2 is suitable for zones where people walk or subject to occasional car traffic.

  • For dry and wet areas
  • For mechanically and chemically loaded surfaces
  • Highly resistant against petrol, oil and softening agents from tyres
  • Low on odour
  • Low inflammability (fire resistance class Bfl - s1 in accordance with EN 13501-1)




Application areas

Impregnation and sealing of:

  • concrete
  • cement screeds
  • existing reaction resin coatings




Substrate preparation

The substrate must be in the following condition:

  • clean and frost-free
  • stable
  • free from grease, water soluble coats, cement laitance, separating agents and loose particles


 Level uneven substrates to avoid puddles from forming.

Storage

cold, dry and frost-free at least 12 months in its original sealed container

Mixing ratio

3 (A) : 1 (B)

Processing time

~ 120 minutes

Walkable

after ~ 16 hours

Fully loadable

after ~ 7 days

Priming with BOTAMENT® BV 2 transparent:

- add B component to A component and mix both together with a slowly rotating mixer for at least 3 minutes

- to prevent mixing errors pour BOTAMENT® BV 2 afterwards into a clean container (scratch the container clean) and mix again

- roll out the ready mixed material with a short-pile sheepskin roller across the entire area



Sealing with BOTAMENT® BV 2 stone grey:

- add B component to A component and mix both together with a slowly rotating mixer for at least 3 minutes

- to prevent mixing errors pour BOTAMENT® BV 2 afterwards into a clean container (scratch the container clean) and mix again

- roll out the ready mixed material with a short-pile sheepskin roller onto the dried primer across the entire area

- apply the top coat onto the dried base layer with a short-pile sheepskin roller


Surface sealings made of BOTAMENT® BV 2 should be done applying at least two layers.

To achieve a slip-resistant surface the first layer of BOTAMENT® BV 2 must be scattered while fresh with dried silica sand of a grain size between 0.1 – 0.3 mm.

Application and substrate temperature

+ 10 °C to + 30 °C

generally 3 °C over dew point

relative humidity ≤ 85 %

Consumption or Usage

transparent ~ 0.15 - 0.20 kg/m²

stonegrey ~ 0.25 kg/m²

Interval between application of layers

≤ 48 hours

Vital information

BOTAMENT® BV 2 must be protected against moisture while curing.


BOTAMENT® BV 2 has been designed exclusively for commercial users.

Container
Container Dispatch unit sold by the pallet Product number EAN Code
Primer 1 kg Tin transparent 6 per box - 50700010115609 4030905110692
Sealant 5 kg Tin bucket stone grey - 56 Units/s 50707300195609 4030905110685
Grundierung 4 kg Tin bucket transparent - - 50700010195609 4030905110760
Downloads
Media Centre
Supplier search
Safety datasheets