Product systems: 2 K-Abdichtungen

RA 170 Reaction Resin Sealant 2c

RA 170

BOTAMENT® RA 170 is a composite sealant used under tiles in interior and exterior areas.

BOTAMENT® RA 170 has been developed especially for the waterproofing of swimming pools and areas which are subject to heavy water loads in connection with chemical exposure as for example in food industry plants or in washing plants.

Moreover BOTAMENT® RA 170 can be applied as a protection coat for garage floors and basement floors.


    • Highly flexibel
    • Crack-bridging
    • High chemical resistance
    • For mechanical stressed areas
    • For steel substrates


      Application areas

      Sealing of:


      • concrete, lightweight concrete and porous concrete
      • joint full brickwork
      • cement screeds
      • plasters of the mortar categories CS II, CS III and CS IV in accordance with EN 998 (compressive strength ≥ 2.5 N/mm²)
      • BOTAMENT® BP building boards
      • fibre cement boards
      Substrate preparation

      The substrate must be in the following condition:


      • dry, clean and frost-free
      • stable
      • free from grease, paint, cement laitance, separating agents, rust and loose particles


      Mineral substrates must be primed with BOTAMENT® E 120.

      Storage

      cold and frost-free at least 12 months in its original sealed container

      Mixing ratio

      2 (A): 1 (B)

      Processing time

      ~ 20 minutes

      Walkable

      after ~ 12 hours

      Fully loadable

      after ~ 7 days

      • add B component to A component and mix both together with a slowly rotating mixer for at least 3 minutes
      • to avoid any mixing mistakes re-pot BOTAMENT® RA 170 afterwards into a clean container (scratch the container clean) and mix again


      BOTAMENT® RA 170 as composite sealant:


      • pour the ready-mixed material from the bucket onto the substrate, spread it all over using a steel smoothing trowel or a rubber squeegee and de-aerate while it is still fresh (insert a spiked aeration roller)
      • apply the second coat onto the dried base layer with a short-pile sheepskin roller or a steel smoothing trowel


      Sealings made of BOTAMENT® RA 170 should be done applying at least two layers.


      The total dry layer thickness of the sealing must reach at least 1.0 mm (correlating with a wet layer thickness of 1.1 mm).


      Prior to fitting of tiles the fresh top layer of BOTAMENT® RA 170 has to be scattered with dried quartz sand of grain size 0.5 - 1.2 mm all over.



      BOTAMENT® RA 170 as protection coat:


      • pour the ready-mixed material from the bucket onto the substrate, spread it all over using a steel smoothing trowel or a short-pile sheepskin roller and de-aerate while it is still fresh (insert a spiked aeration roller)
      • apply the top coat onto the dried base layer with a short-pile sheepskin roller


      Protection coats made of BOTAMENT® RA 170 should be done applying at least two layers.

      Application and substrate temperature

      + 10° C up to + 30° C

      Consumption or Usage
      • Use as composite sealant: ~ 1.1 kg/ m2/ mm
      • Use as protection coat: ~ 0.6 - 1.2 kg/ m2/ mm (depending on the substrate condition)
      Vital information

      BOTAMENT® RA 170 has been designed exclusively for commercial users.

      Container
      Container Dispatch unit sold by the pallet Product number EAN Code
      9 kg Tin bucket grey - - 54930700235609 4030905120202
      Downloads
      Supplier search
      Safety datasheets